|Montagesystem Ordnung||Reihen, Säulen|
|Modul Orientierung||Hochformat, Querformat|
|Supporting Material||Aluminium, Edelstahl|
|Kleinteil Werkstoffkunde||Aluminium, Edelstahl|
|PDF Datei des Unternehmens Herunterladen|
This types of L feet have been widely used on universal corrugated metal sheet roof. It can fix to the roof rafter directly. Also, it can be applied with hanger bolts and Kseng deigning roof clamps.
|L foot Solar Rooftop Mounting System For Metal Roof|
|Material||Aluminum & Stainless Steel|
|Installation Site||Tin Roof|
|Warranty||10 Years Warranty, 25 Years Service Life|
L Foot Tin Roof Mounting System Advantages
1. Easy to use. Which is manufactured of high quality aluminum 6005-T5& SUS 304 Stainless steel, very lighweight and easy to installation,can save construction time and labor cost.
2. Cost-effective for both framed and unframed solar panel mounts
3. Tilt angle can be adjustable from 5 degrees to 60 dedgrees .
4. We have Different Solutions to meet different customer's requirements.
1. Drill a hole in the right position as planned, install the EPDM rubber and L-bracket, then screw the bolt into the wooden beam below.
2. Section of L-bracket after installation. Please be careful during installation, not destroy the steel below.
3. Mount the clamp and L-shaped bracket to the roof rail. confirm and tighten the bolts. Both rails must be on the same level.
4. The module is secured to the roof rail by end clamps. As shown on the right. First, the panel is placed flat on the rail, then the rail clip is snapped into the rail slot and finally the end clamp kit is installed.
5. Portrait solar panel, Solar panel Length(should check the solar panel install instruction). Landscape solar panel, solar panel width.
6.L-bracket horizontal spacing can be up to 2m. L- bracket upward spacing is about 1/2 or 3/4 the length of solar panel. Spacing between solar panel:18mm.
Xiamen Kseng Metal Tech Co., Ltd.
Driven by the mission of” Empowering our world with clean energy ”, Kseng solar has increased its global presence with branches and offices in South Korea, Japan, Australia, Malaysia, Vietnam, Hong Kong S.A.R and other countries and regions. And it has up to 6GW annual production capacity with manufacturing base in Indonesia, Malaysia, Fujian and Tianjin.
Since the inception of 2015, Kseng solar has a proven track record as the ideal racking brand for its strong engineering, manufacturing and customer service capability. With its own manufacturing base to conduct strict quality control and numerous international standards accreditation, Kseng solar has accomplished more than 5GW of solar racking shipments by the end of 2021. Among them, it has ranked No.1 in Korea’s solar racking market and keeps the best annual growth rate for six consecutive years in Japan market.
we have two production line, first one is for solar mounting system, another one is for ground screw.
There are some of Kseng's Project cases,